Peak Design Works P-Cool

RETURN ON INVESTMENT
Not only will the Programable Coolant Nozzle Kit save money in tools it will pay for it's
self in coolant savings alone. Less make-up coolant is used because 75% of the
coolant isn't making mist. Our coolant usage has been reduced by 5-10 gallons a day
on some jobs! If your shop is on the warm side and are using higher spindle speeds
you may see even a greater reduction of coolant usage. Those savings add up fast
when you figure in the cost of coolant concentrate. This one upgrade really does make
a difference and is the most cost effective investment you can make in your Haas
HS-1 short of buying a new one. And this installation has a better coolant stream angle
than the new EC-400 with programable coolant! There you go, we just saved you
$160,000.

SAFETY
Operators no longer have to stop the machine and lean into the work area to adjust
nozzles thus avoiding possible contact with sharp tools, chips and coolant drips and
splashes.

With 75% less splash workpiece visibility in the machine is greatly improved.

The amount of mist pumped into the shop air is noticeably reduced for a better work
environment.

Leaks and drips are reduced because only one stream is aimed at the cutting area,
and it's actually hitting the cutting area!