Peak Design Works P-Cool2

Anyone operating a Haas HS-1 Horizontal Machining center knows that coolant control
is a big problem. The factory nozzles throw lots of coolant but not always where it's
needed for most tools. 24 tools and only 4 nozzles means that most of the tools are
not getting the best application of coolant. Good enough? Tell that to that to the 2-56
tap down in the bottom of a pocket! TSC (through spindle coolant) only works on tools
large enough to have a hole through the center and those tools are a bit pricey.

This fully programmable coolant nozzle kit addresses all these problems and more.
Seamlessly integrates with the Haas control to operate just like the factory P-Cool
option with nozzle offsets set on the offset page of the control. Automatically moves
out of the way of the tool carrosel while the tool is changed and then moves back into
position after the tool change is completed. No special programing is required. Each
tool can have it's own programed nozzle position to apply the coolant in exactly the
best spot, and it can also be adjusted while cutting without stopping the machine or
reaching into the cutting area! And how about being able to blast a concentrated
stream of coolant directly at a tap instead of just splashing somewhere close!